Installation Manual - Low Voltage Inlets

The following are differences in standard low voltage mounting plates.

Standard Plastic Plate
Installation Parts		 Standard Metal Plate
Installation Parts		 Short Tight Plate
Installation Parts

The photos below show the differences in space between the plate and pipe.
(The far right "Short Tight 90" and special mounting plate are used
inside walls not deep enough for the standard Tight 90. The plastic
moulded screw tap on top is cut in half to allow the pipe to be so close.)

The photos below shows what they look like mounted on studs.
  1. Introduction
  2. Power Unit /
    Inlet Valve Location
  3. Planning the Tubing System
  4. Cutting & Cementing PVC /
    Low Voltage Wire
  5. Central Vacuum Inlets
  6. Existing Home Installation
  7. New Construction Installation
Download Installation Manual
Next