MAXI VAC Filter?
I HAVE A MAXI VAC INSTALLED 1974. IT WAS MANUFACTURED BY WARD MFG. DALLAS, TX. S/N M1292 MOTOR 1.9HP VOLTAGE 115AC AMP 13.1 MAX.
THE FOAM FILTER IS MISSING. I DON'T KNOW MEASUREMENT. DO I NEED TO MEASURE THE INSIDE POST, WIDTH, AND DEPTH. PLEASE ADVISE.
THANK YOU, GAIL COLEMAN GREENSBORO, NC
Hi, you will probably take the 6x6 or 8x8. Basically you want it not too close to the inner diameter. The 8x8 may be too wide. The two inch hole in the filter can go over a long metal post, or other object. Sometimes there was a wing nut and washer, or a retainer plate to keep it from falling down. But if yours is a 2-inch diameter post then you can use one of these filters as well.