Excellent replacement for all single motor 110 volt central vacuums with a separate relay/transformer/breaker or with a single control board. Some retrofitting may be required.
Compatible and Durable. This very durable, industry standard, Alutron control board contains a relay, transformer, 15 amp mini breaker, and two pairs of low voltage leads (wire set and black tower with flag terminals).
Installation. Circuit board control module is 2" high from board to top of reset button. The reset button and low voltage stems are threaded. When put through holes in the body of the vacuum, the two stems hold the board in place with two included thin mounting nuts. If you don't have a proper hole for installation you can use a drill and step bit to create proper holes. NOTE: It is recommended that an electrician should install this board. It should take them less than an hour.
Wiring. Click on the photo and print it to use as a wiring guide. The connections are 1/4" flag terminals. We recommend purchasing quarter inch female flag terminals to put on the motor and power cord wires, or buying our wire set with terminal ends and striping them into the wires with wire nuts. Wiring locations on the board: